Replacement Trace SW FET Power Board

[Hisham Amaral]

(06-22-2020 19:07)davidbrady Wrote:  Here's a printed circuit board layout I just completed which adds an ethernet connector and tcp/ip stack to the inverter. This board uses a Microchip PIC32 microcontroller. Once I put a BOM (bill of materials) together I'll send it out to have it fabricated. Installation is simple, just remove one of the 8 bit micro's on the existing board and plug this board into the 8 bit socket and you now have monitoring and control of your inverter over the inter or intranet. Next up is completing the entire PCB control card.

Wow David that is great looking board. Sue and I are back looking at Prevost without slides I will let you know if I find a good one to buy, the other requirement is roof air a must. I spoke with Greg and Micheal at Featherlight they told me the none slide unites had issues with their Crusie airs not running at hi temp area. Will keep posted.