Replacement Trace SW FET Power Board
|
06-22-2020, 19:07
(This post was last modified: 06-22-2020 22:33 by davidbrady.)
Post: #65
|
|||
|
|||
RE: Replacement Trace SW FET Power Board
Here's a printed circuit board layout I just completed which adds an ethernet connector and tcp/ip stack to the inverter. This board uses a Microchip PIC32 microcontroller. Once I put a BOM (bill of materials) together I'll send it out to have it fabricated. Installation is simple, just remove one of the 8 bit micro's on the existing board and plug this board into the 8 bit socket and you now have monitoring and control of your inverter over the inter or intranet. Next up is completing the entire PCB control card.
david brady, '02 Wanderlodge LXi 'Smokey' (Sold), '04 Prevost H3 Vantare 'SpongeBob' "there is no perfect forum there are only perfect forums" |
|||
The following 1 user Likes davidbrady's post: Robert Britton (06-24-2020) |
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 3 Guest(s)