Prevost Gurus - the Member Funded Prevost Forum / Discussions / Electrical v / Replacement Trace SW FET Power Board

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replacement Trace SW FET Power Board
05-19-2020, 21:15 (This post was last modified: 05-19-2020 22:10 by davidbrady.)
Post: #64
davidbrady Offline
Senior Member
****
 		Posts: 595
Likes Given: 51
Likes Received: 32 in 26 posts
Joined: Aug 2014
Reputation: 4
RE: Replacement Trace SW FET Power Board
Finally got a TCP/IP stack embedded into the inverter. I'm running data over a publish/subscribe protocol called MQTT. MQTT has become the defacto standard for IOT devices. In the video I start three loads one by one, a hair dryer, a space heater, and a grinder. I then turn off each one by one, then I plug into shore power for a quick charging session. Next up is a PCB design for my control board. Enjoy!



david brady,
'02 Wanderlodge LXi 'Smokey' (Sold),
'04 Prevost H3 Vantare 'SpongeBob'

"there is no perfect forum there are only perfect forums"
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Replacement Trace SW FET Power Board - davidbrady - 05-19-2020 21:15



User(s) browsing this thread: 1 Guest(s)

Contact Us | Prevost Gurus - Free Classifieds & Support Forum Community Service | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication