Prevost Gurus - the Member Funded Prevost Forum / Discussions / Electrical v / Replacement Trace SW FET Power Board

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replacement Trace SW FET Power Board
04-25-2019, 15:25
Post: #19
davidbrady Offline
Senior Member
****
 		Posts: 595
Likes Given: 51
Likes Received: 32 in 26 posts
Joined: Aug 2014
Reputation: 4
RE: Replacement Trace SW FET Power Board
Hi Jerry,

Thanks! I appreciate the help. Below is a pic of the Power Board. You can see where a few of the FETs are attached. The holes are 3.6mm diameter for 10 AWG tinned/stranded wire. These wires carry 24VDC in/out and +-24VAC in/out from the H-Bridges prior to stepping up by the three transformers. One of the items that needs to be worked out is finding a supplier for 10AWG tinned wire and finding a CM that's willing to solder them in. I'll inevitably do some final assembly, but I'm trying to offload as much as I can. Maybe you have some insight.


Attached File(s) Thumbnail(s)
İmage
david brady,
'02 Wanderlodge LXi 'Smokey' (Sold),
'04 Prevost H3 Vantare 'SpongeBob'

"there is no perfect forum there are only perfect forums"
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Replacement Trace SW FET Power Board - davidbrady - 04-25-2019 15:25



User(s) browsing this thread: 2 Guest(s)

Contact Us | Prevost Gurus - Free Classifieds & Support Forum Community Service | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication