Prevost Gurus - the Member Funded Prevost Forum / Discussions / Electrical v / Replacement Trace SW FET Power Board

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replacement Trace SW FET Power Board
02-16-2017, 15:58 (This post was last modified: 02-16-2017 18:43 by travelite.)
Post: #5
davidbrady Offline
Senior Member
****
 		Posts: 595
Likes Given: 51
Likes Received: 32 in 26 posts
Joined: Aug 2014
Reputation: 4
RE: Replacement Trace SW FET Power Board
Hi Hish,

Sorry for the delay; I've been immersed in the mosfet driver cards. As cool as the Han Fast Locks are, I'm afraid I don't have the room on the board for them. They need a 10mm diameter base circle which is more than I can free up. Soldering is probably the only approach that will work.

Check out these cool bus bars. These are needed to distribute both the low and high voltage across the board:
.pdf  E-FAB_PCB_Bussbars_Stiffeners12162015(1).pdf (Size: 1.14 MB / Downloads: 8)
david brady,
'02 Wanderlodge LXi 'Smokey' (Sold),
'04 Prevost H3 Vantare 'SpongeBob'

"there is no perfect forum there are only perfect forums"
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Replacement Trace SW FET Power Board - davidbrady - 02-16-2017 15:58



User(s) browsing this thread: 3 Guest(s)

Contact Us | Prevost Gurus - Free Classifieds & Support Forum Community Service | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication