+- Prevost Gurus - the Member Funded Prevost Forum (http://www.prevostgurus.com)
+-- Forum: Discussions (/forumdisplay.php?fid=25)
+--- Forum: Chassis (/forumdisplay.php?fid=31)
+--- Thread: U.S. Federal Certification Label (/showthread.php?tid=1236)
Pages: 1 2
U.S. Federal Certification Label - Jerry_94110 - 06-25-2019 15:45
I took the bus to DMV to get license and we were not able to find the U.S. Federal Certification Label for as a secondary verification.
Does anyone know where this label may be located on a 1998 XL40?
RE: U.S. Federal Certification Label - Ernie Ekberg - 06-25-2019 17:01
I have never heard of such a label. My bus has no stickers on the outside.
RE: U.S. Federal Certification Label - Jerry_94110 - 06-25-2019 18:18
The California DMV requires a secondary verification and they use the U.S. Federal Certification Label to do it. On a car, it is normally located on the jamb of the driver's door.
It ensures motor vehicles sold in the U.S. meet specified safety standards and also list the VIN number of the vehicle.
RE: U.S. Federal Certification Label - Jerry_94110 - 06-26-2019 14:22
I called Prevost....They said that all bus have a U.S. Federal Certification Label. They said if you are standing in front of the bus looking at it. It should be located on the driver side lower windshield area or on the column between the dash and the roof. I will check this weekend. I am thinking that Vantare may have covered it when doing the conversion.
RE: U.S. Federal Certification Label - Robert Britton - 06-27-2019 20:15
On my 99 it is riveted to the chrome passenger side defrost vent, you can see it when standing outside the bus looking through the windshield...thinking maybe Marathon relocated it there? There is another in the engine bay.
It's never fun dealing with California DMV when bringing a bus in from out of state. Every time I did I had to go back several times as each visit they would come up with something new that I needed (CHP inspection, smog test, weight tag). I would go back home and research from their web site, print it out, make another appointment to show them what they were asking for was not required.
Luckily my Prevost was already registered in California when I bought it so the DMV transfer was straight forward. The last Bluebird I bought from out of state I contacted a DMV approved third party registration service. For a fee he came to my house and did all the paperwork, the bus never left the barn, however he did verify the Federal Certification labels that you're asking about.
I used "Conar Registration Service" out of San Jose.
Mario Santos
408-258-4000
RE: U.S. Federal Certification Label - Ernie Ekberg - 06-28-2019 07:57
wow- so much red tape
RE: U.S. Federal Certification Label - Hisham Amaral - 06-28-2019 11:28
FMVSS 201 requires a vin plate be displayed and is in visible range by the drive side of the vehicle. The law may have change since 2006 but the passed 2 Prevost we owned the vin plate was on the driver side lower edge of the W/S and above the instrument panel.
RE: U.S. Federal Certification Label - Jerry_94110 - 06-28-2019 14:37
(06-27-2019 20:15)Robert Britton Wrote: I used "Conar Registration Service" out of San Jose.
Mario Santos
408-258-4000
Thanks Robert, If my second round at DMV does not produce a license, I think I will call Mario Santos.
I was also thinking about looking into a Montana license. I see adds for attorneys in the FMCA magazine. I am not sure how having a license plate from Montana would weather in CA.
RE: U.S. Federal Certification Label - cubeman - 06-29-2019 20:26
Open the door under the drivers seat . You should see the VIN # it should be riveted to the door . Or check next to the drivers seat .
RE: U.S. Federal Certification Label - Jerry_94110 - 07-01-2019 15:42
Thanks Al. This weekend, I did find it on the door under the drivers seat.......